1024-LDH2: 92 KHz InGaAs線掃描相機(jī)
|
電光性能 |
||||||
|
Sensor format 1 |
1024 pixels on 25μm pitch with 8 readout ADCs |
|||||
|
Optical aperature (pixel height) |
500μm or 25μm (square pixel sharply defined by mask on detector surface) |
|||||
|
Peak quantum efficency |
> 70% |
|||||
|
Gain capacitor setting Net full well capacity (Me-)2 |
0.1 pF |
1 pF |
10 pF |
|||
|
Typical |
Specification |
Typical |
Specification |
Typical |
Specification |
|
|
2.0 |
>1.4 |
8.7 |
>7.7 |
85 |
>70 |
|
|
Gain (e-/cnt)1 3 |
540 |
< 620 |
2200 |
< 2450 |
21400 |
< 24500 |
|
Temporal noise (rms counts)1 2 |
2.0 |
< 2.4 |
1.6 |
<1.8 |
1.3 |
<1.4 |
|
Dynamic range1 2 4 |
1900:1 |
> 1350:1 |
2600:1 |
> 2100:1 |
3100:1 |
> 2600:1 |
|
Differential non-linearity1 2 |
+/- 0.8% |
< +/- 1.2% |
+/- 0.8% |
< +/- 1.2% |
+/- 0.8% |
< +/- 1.5% |
|
Bad pixel specification |
White, dark, noisy or pixels exceeding +/- 10 of the mean value when illuminated at 50% of full well |
|||||
|
Number of bad pixels limited to a maximum of 1% of array total; no bad neighbors within 5 pixels |
||||||
|
Exposure time1 3 |
0.007 ms to 1 ms in preset modes or to > 1 s with user programmed or via the width of the ext. trigger |
|||||
|
Trigger modes 3 |
Free run, single line per trigger, variable exposure, or gated burst |
|||||
|
Sync output |
SMA connector: digital signal, high during integration |
|||||
|
External trigger 3 |
Three modes via CC1 or SMA |
|||||
|
External variable ET |
User set by the duration of trigger input signal (minimum ET pulse: 10μs) |
|||||
|
External trigger jitter |
+/-1 clock cycle: nominally 80 ns with internal ET |
|||||
|
Pixel rate |
100 Mpix/s max with 2 x 12-bit words transferred on each Camera Link strobe clock at 50 MHz |
|||||
|
Digital output format |
12-bit base Camera Link?; recommend NI PCIe-1427 or equivalent frame grabber |
|||||
|
Readout mode |
Integrate while read, differential double sampling |
|||||
|
Corrections (preset OPR) |
Factory calibrated gain, offset, and bad pixel replace, applicable to the center 90% of the array |
|||||
1Actual formats and performance governed by user-selected SUI linear array purchased with camera (dark current may limit longest usable ET)
2Camera readout noise limited for low & medium gain settings; dark shot noise limited for high gain settings
3 User selectable by command over Camera Link? serial lines
4 Dynamic range limited to maximum values listed when camera operated at exposure times shorter than 28 μs due to reduced full well capacity。
*
|
Interfaces |
|
|
Control: |
SDR 26-pin connector (Base Camera Link?) |
|
Image Data: |
SDR 26-pin connector (Base Camera Link?) |
|
Power: |
Hirose HR10-7R-6PA receptacle | Mates with HR10-7P-6S or SN4-8-6 (P) |
|
Sync Output: |
SMA: 5 V, 50Ωseries terminated, active high: integration active |
|
Trigger: Input |
SMA, Low < 0.5, 3 V > high < 5 V |
|
Status LED: |
Green: TEC locked at setpoint|Red: TEC unlocked |Blinking: Timing or triggering error |
*
|
環(huán)境及電源要求 |
|
|
Operating temperature: |
-10°C to +50°C case temperature |
|
Storage temperature: |
-20°C to 70°C |
|
Humidity: |
Non-condensing |
|
Power requirements: |
100-240 VAC, 47-63 Hz, < 1.0 A |7-16 V, < 6 W at 25°C, <9 W at 50°C |< 1.5 A peak |
*
|
機(jī)械尺寸 |
|
|
Length x Width x Height: |
6.1 cm x 7.37 cm x 7.62 cm |
|
2.4 in x 2.9 in x 3.00 in |
|
|
Length excludes I/O connectors, and lens adapter |
|
|
Weight: |
< 450 g or 1 lbs (no lens or adapter) |
|
鏡頭座及適配器 |
M42x1-6H with 5.7 mm to image plane none, fixed distance C-Mount adapter or adjustable distance F-Mount adapter (see ordering info) |
|
光譜儀安裝座: |
4 tapped 8-32 holes in 2 inch square pattern |
|
4 tapped M4x0.7-6H holes spaced 5 cm x 4 cm (h x w) O-Ring light seal, 1.9 inch diameter, 1/16th thickness |
|
|
Camera Tripod mount: |
2 tapped?-20 holes alternating on?”(19 .05 mm) spacing with 2 tapped M6-6H holes |
|
Side wall mounts: |
4 tapped M4x0.7-6H holes, 5 x 4.5 cm spacing (h x d) |
*
|
訂購(gòu)信息 |
|||||||
|
Camera Model1 |
Part Number |
Max. Line Rate1 |
Pitch |
Pixels |
FPA Length |
Aperture (Height) |
Classification |
|
SU1024-LDH2-1.7RT-0500/LC |
8000-0480 |
91,911 lps |
25μm |
1024 |
25.6 mm |
500μm |
EAR99 |
|
SU1024-LDH2-1.7RT-0025/LC |
8000-0484 |
91,911 lps |
25μm |
1024 |
25.6 mm |
25μm |
6A003.b.4.a |
